GEN2012-TBSA-03 - Setco / CSE Ex d Junction Box

On 12 November, 2012
By

Technical Bulletin / Safety Alert

Unique ID No: GEN2012-TBSA-03 Rev: 0

(This document supersedes all previous versions of the above TBSA - N/A)

Subject: Setco / CSE Ex d Junction Box

Date: 7th November 2012

Applicable to: All Machines (where installed) Note: Minimum PPE required to carry out any inspections contained in this TBSA shall be protective clothing & footwear, safety glasses, hearing protection & any site specific requirements. A JSA or equivalent should be carried out prior to performing these tasks.

Occurance: Setco Australia Pty Ltd has released the attached Technical Information Bulletin / Safety Alert Doc No. 200 in relation to Ex d Junction Box (Part No. FJB2C-SETCO3 / 151452) having "a machining dimensional discrepancy that has been identified as being outside  the scope of IEC 064/01 Clause 5.2.4.1 - Figure 3".

VLI Diesel Division (VLIDD) advises that the abovementioned Junction Box has been installed to some VLI machines.

 

Recommendations: Where Setco Ex d Junction Box (Part No. FJB2C-SETCO3 / 151452) is installed to VLI equipment, IMMEDIATELY inspect as per the attached Setco and SLA documents. Where assistance is required in relation to this TBSA, please contact VLI Diesel directly.

Supporting Documentation: Setco Australia Pty Ltd Technical Information Bulletin / Safety Alert Doc No. 200

Please ensure this document is circulated to all relevant personnel within your

organisation.

Click Here to download Technical Bulleting and Supporting Documents